Design of Steel Structures
Assignment I
1.
Write a short note on
a.
Advantages & Disadvantages of steel as a
structural material
b.
Making of Steel
c.
Concept of limit state
2.
Design a lap joint to connect two plates 300mm
wide and 16 mm thick using 20 mm diameter bolts of grade 4.6. the applied
service load of 375 kN.
3.
Design a fillet weld to join a tension member
consisting of 2 ISA 100mmx75mmx8mm to 12
mm thick gusset plate. The factored tensile load is 400 kN.
4.
Design a tension member to carry a pull of 800
kN. The member is 3.2 m between c/c of intersections. Design the member using
channel section.
5. Compression member problem - the problem discussed in the class.
No comments:
Post a Comment